Table of Contents
Advertisement
CONTROL HUB WIRING - INVERTER
• Consult your inverter's user guide prior to installing through the hub.
• Take into consideration the appropriate cable gauge and fuse size needed to run your inverter. You
will need to use heavier gauge cables running from both the battery into the hub and from the hub
to the inverter.
• Some cables used will be too large to fit into the existing rubber grommets. You may need to modify
the box, drilling in larger holes to fit them.
• The positive and negative cables used to connect to the box should have 8mm eye terminals.
PROCESS
1.
Remove the front face of the unit by unscrewing the four screws found on each corner.
2.
Locate a practical route for the wires to enter the hub from the appliance. Run your leads from the
inverter into the box through one of the four grommets, or drill another hole if necessary.
3.
There should be a vacant large bolt on the positive busbar. Secure the positive lead to this bolt.
4.
Repeat the process above for the negative lead to the negative busbar.
INSTALLATION
10
Advertisement
Table of Contents
