GE 22 Owner's Manual & Installation Instructions page 20

Installation instructions
REVERSING THE DOOR SWING (CONT.)
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
Remove the base grille by pulling it straight out.
Using a socket driver, move the bottom hinge
bracket ti'om the right side to the lett side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the door.
[]
TRANSFER CENTER HINGE
BRACKET TO THE LEFT
I_.emoxe the center hinge bracket b _, ren/oxino
the three screws.
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when
installing the hinge on the other side.
You will need to remove the coloi_nmtched cap
from the screw head befi)re you can relnove the
screw, Use the edge of a thin flat blade to gently pry
the caps off the screw heads, (A putty knife works
well fi)r this,) Cover the blade with tape to i_revent
scratching the paint,
Relnove the inullioi_ cover fl'Oln the left side using
the thin flat blade, Asselnble it to the right side,
Relnove the screw fl'Oln the center leit side of the
cabinet, Screw it into the holes on the right side,
Place the center binge bracket over the holes at the
center leii side of the cabinet. Insert and tighten the
three long screws.
Replace the cap by snapping it over the screw with
VO//r
tiIlgeI',
_._,,...o_L Screw Cap
Mullion Cover
[] TRANSFER DOOR STOPS
On each door, inoxe the metal door stop froln the
right to the letL
Moxe any screws froll_ the leii to the iight.
20