Summary of Contents for Dust Free LIGHTSTICK 19300
Page 1
LIGHTSTICK ® Germicidal UV-C Ultraviolet Light Installation & Operation Manual GENERAL This product emits germicidal ultraviolet (UV-C) light to dose the cooling coil, drain pan, and internal surfaces of HVAC systems for improved indoor air quality where the light shines. Lightstick #19300 BEFORE INSTALLING OR INCLUDED INSIDE BOX...
U.S. Patent Nos. 5,334,347, 5,817,276, 6,245,293, 6,267,924, 6,280,686, 6,313,470, 6,627,000, 6,539,727, 6,932,494, 6,550,257. EPA Establishment No. 73316-TX-1 Dust Free® uses independent labs and universities for product testing. Visit http://www.dustfree.com/testing. The product and technologies described are not medical devices, and are not intended to diagnose,...
Page 4
DUST FREE LIGHTSTICK INSTALLATION & OPERATION MANUAL ® ® UV INSTALLATION NOTES • Unintended use of the appliance or damage to the housing may result in the escape of dangerous UV-C radiation. UV-C radiation may, even in small doses, cause harm to the eyes and skin.
Page 5
DUST FREE LIGHTSTICK INSTALLATION & OPERATION MANUAL ® ® UV INSTALLATION LOCATION The power module must be mounted directly to a metal surface. This will help the ballast dissipate heat. Failing to mount the ballast properly will void warranty and may lead to pre-mature UV lamp failure.
DUST FREE LIGHTSTICK INSTALLATION & OPERATION MANUAL ® ® REMOTE LAMP INSTALLATION (A-Coil Delta Plate) • Drill a 7/8” knockout into the delta plate and place gasket (included) around knockout. • Insert lamp directly into knockout and secure the lamp to the delta plate with two self-drilling screws.
DUST FREE LIGHTSTICK INSTALLATION & OPERATION MANUAL ® ® DIRECT LAMP INSTALLATION (A-Coil Delta Plate) • Drill a 7/8” knockout in the outer sheet metal where the lamp will be centered on the return side of the coil. See diagram.
Page 8
DUST FREE LIGHTSTICK INSTALLATION & OPERATION MANUAL ® ® REMOTE LAMP INSTALLATION (W-Coil / A-Coil Bracket Mount) • Disconnect power to the air handler and open access panels. • Slit insulation on the back or side wall of air handler and attach bracket using screws.
Page 9
DUST FREE LIGHTSTICK INSTALLATION & OPERATION MANUAL ® ® UV-C HAZARD LABEL PLACEMENT • To comply with UL Standards, a UV-C Radiation Hazard label must be placed on any doors or access panels which can expose an operator to more than 1.7 μW/ cm2 of UV intensity.
• Lamp does not require any routine maintenance, such as cleaning. • Reference specifications page for lamp replacement schedule and replacement part numbers. WARRANTY REGISTRATION Register all new Dust Free equipment online at https://dustfree.com/resources/warranty/ NOTICE Replace Lamp Per Recommended Maintenance Schedule. UV-C lamps expend their germicidal effectiveness over time.
Dust Free LP’s exclusive obligation under this warranty shall be to supply, without charge, a replacement for any covered component of the Lightstick which is found to be defective within the parameters defined herein. Dust Free LP reserves the right to replace or repair the defective part or component.
Need help?
Do you have a question about the LIGHTSTICK 19300 and is the answer not in the manual?
Questions and answers