Sharp VC-780E Service Manual page 7

¥,
VC-790ET
2] aw |
JIGDRIVER-6 a
Torque Driver
JiGTD1200
JIGDRIVER1 10-7
This Screwdriver is used for
adjusting the guide roller height
and X-position.
This Jig is used for adjusting the
tension band and tension plate.
Tension Band and Plate Adjusting Jig
This is used to screw down resin-
made parts: the specified torque is
5 kg.
This Jig is used for height
adjustment of the A/C head.
Box Driver
This Jig is used for height
adjustment of the retaining guide.
JiGDRIVER1 10-4
" a
JiGRVGH-F1i8 =| BU ar
This Jig is used for height
This Jig is used for height
adjustment of the reverse guide.
Reverse Guide Height Adjusting Jig