Table of Contents
Advertisement
USE OF LEARNING FUNCTIONS
ueann (*)
TRanewer
SR
use
wineo
RECALL oes LEARN
power
TAPE/VCR
Ce Go
st yanr
EI CI Go Gd oe
T VER CH
@ LEARN indicator
This indicator lights when the Learn function is operating.
LIT:
Learning is possible.
OFF:
Regular remote contro! functions can be performed.
NOTE:
If the LEARN indicator flashes, it indicates that the program capacity
has been exceeded and that the fast command has not been properly
memorised. All previously programmed commands will, however, be
retained in memory and can be used as they are if the last command
is not essential.
@ TRANSMIT indicator
This indicator flashes when remote control signals are sent.
@ LEARN selector switch
This can be set as follows:
LEARN:
This position is used for storing the codes of your remote control unit.
USE:
Set to this position after codes have been stored in the LEARN position.
{Set to this position when using memorized commands.)
SR RECALL:
Set to this position when transmitting Pioneer unified remote control
code signals (Marked on the remote control unit).
Set the TRANSMIT
MODE switch to AUDIO or VIDEO. In the AUX
mode, only the receiver remote control code is transmitted.
28
<ARB1177>
Operation Example
Using the remote control unit of your VCR to program the playback
command.
«It is recommended
that the name
of the key and its function
correspond. This is convenient when operating equipment.
1. Set the LEARN switch of the programmable remote control unit
to the LEARN
position and set the TRANSMIT
mode selector
switch to the VIDEO position.
* Programming is possible with the TRANSMIT mode selector
switch in any position, but VIDEO is used as an example.
2. Place the transmission sections of the programmable remote
control unit and the remote contro! of the VCR facing each other.
2 to 5.cm (1 to 2 inches)
-
rs
——F
FETTTL
7
© Place the two units on a table, separated by 2 to 5m
(1 to 2
inches).
Memorization will not be possible if they are too close.
3. Hold down the VCR PLAY (> ) key of the programmable remote
control unit until the LEARN indicator lights up, then release the
key.
4. Hold down the PLAY key of the VCR remote control unit.
5. Release the key of the VCR remote control unit after making sure
that the LEARN indicator has gone out on the Pioneer remote
control unit.
6. Set the LEARN selector switch of the programmable remote control
unit to the USE position,
P
* The previous code (Pioneer uniform remote control code or code
for other equipment) is erased and replaced by the new code.
7. Check that the program works.
.
* Try actual operation and make sure the unit works properly.
iy)
If the VCR does not operate when pressing the key, change angle,
*-
position and distance between both remote control units and
repeat the programming procedure,
* When programming, make sure that the function indications (for
example,
, »r, Ml) on the other remote control unit and the
programmable remote control unit are the same. This will facilitate
operation.
Advertisement
Table of Contents
