Sub-Zero UC-15I Quick Start Manual page 3

6 Repeat for the other water line.
7 Remove the water filter manifold from the unit.
INSTALL THE WATER FILTER MANIFOLD
1 Insert one of the water lines into the water filter
manifold.
2 Insert the locking clip below the collar.
3 Pull the black insulation up around the water fitting.
4 Repeat inserting the water line and installing the
locking clip on the other water line.
5 Push the water filter manifold back into the unit.
5
6 Use a / " socket to install the water filter manifold
16
mounting screws.
INSTALL THE ENCLOSURE
1 Insert the enclosure into the unit.
2 Lift the rear notches of the enclosure up past the
tabs.
3 Lift the front of the enclosure, then pull the enclosure
forward.
INSTALL THE LOWER COVER ASSEMBLY
1 Insert the lower cover assembly into the unit.
2 Push the lower cover assembly up until it is aligned in
the unit.
INSTALL THE BOTTOM FRONT RAIL FRAME
1 Insert the lower part of the bottom front rail frame
over the side panel tabs.
7045211 REV A 7/2023
UC-15I Water Filter Manifold Replacement
2 Rotate the bottom front rail frame up and align it
below the lower cover assembly.
5
3 Use a /
frame mounting screws.
INSTALL THE BOTTOM RAIL TRIM
1 Place the bottom rail trim over the bottom front rail
frame.
5
2 Use a /
mounting screws.
INSTALL THE KICKPLATE
1 Place the kickplate onto the unit.
5
2 Use a /
screws and plastic washers.
INSTALL THE WATER FILTER
TIP: Install the water filter if it was removed.
1 Insert the water filter into the water filter manifold.
2 Rotate the water filter clockwise until it stops.
INSTALL THE DOOR WITH HINGES
1 Align the upper and lower hinge key holes over the
outer cabinet hinge screws.
2 Push the door assembly toward the unit cabinet.
3 Use a Phillips screwdriver to install the inner cabinet
hinge screws.
4 Use a Phillips screwdriver to tighten the outer cabinet
hinge screws.
5 Check the alignment of the door assembly.
6 Install the hinge covers over the door hinge screws.
Page 3 of 3
www.subzero-wolf.com
" socket to install the bottom front rail
16
" socket to install the bottom rail trim
16
" socket to install the kickplate mounting
16
(800) 222-7820