Sub-Zero UC-15I Quick Start Manual page 2

REMOVE THE BOTTOM RAIL TRIM
5
1 Use a / " socket to remove the bottom rail trim
16
mounting screws.
2 Remove the bottom rail trim from the unit.
REMOVE THE BOTTOM FRONT RAIL FRAME
5
1 Use a / " socket to remove the bottom front rail
16
frame mounting screws.
2 Rotate the front of the bottom front rail frame down,
then pull the bottom front rail frame forward.
3 Remove the bottom front rail frame from the unit.
REMOVE THE LOWER COVER ASSEMBLY
1 Pull the lower cover assembly downward and remove
it from the unit.
7045211 REV A 7/2023
UC-15I Water Filter Manifold Replacement
REMOVE THE ENCLOSURE
1 Push the enclosure toward the back of the unit.
2 Pull the front of the enclosure down.
3 Pull the rear notches of the enclosure down past the
tabs.
4 Remove the enclosure from the unit.
REMOVE THE WATER FILTER MANIFOLD
5
1 Use a /
mounting screws.
2 Pull the water filter manifold forward.
3 On the first water line, pull the black insulation down
the water line, exposing the locking clip.
IMPORTANT: Do not remove the glued, gray
insulation from the water filter manifold.
4 Use a small flat-blade screwdriver to remove the
locking clip.
5 Push the collar around the water line up toward the
fitting, while pulling the water line away from the
manifold.
Page 2 of 3
www.subzero-wolf.com
" socket to remove the water filter manifold
16
(800) 222-7820