Advertisement
1/6.Turn On/Standby
Press this key to turn on unit or switch to standby mode. At power
on, unit will automaticly turn on and restore to previous status .
2/10. Dynamic Mode Adjust
Switch to dynamic mode from static color, or switch between
dynamic modes.
3/7. Dynamic Speed Adjust
Adjust dynamic playing speed. Press SPEED+ to increase speed
and press SPEED- to decrease. Unit will switch to dynamicmode
If press this key at static color mode.
4/5. Static Color Adjust
Switch to static color mode from dynamic mode, or switch
between static colors.
8.Demo Mode
Press this key will switch to Demo mode. At demo mode, it
plays 17 dynamic modes in loop, each mode repeat 3 times.
10/12. Brightness Adjust
Adjust static color brightness. Press BRIGHT+ to increase
brightness and press BRIGHT- to decrease, Unit will switch to
static color mode if press this key at dynamic mode.
11. Direct Color Select
Shortcut key to static colors, When press the specific color
key, LED will play the same static color. The direct colors
are includedin"COLOR+' and"COLOR- operation.
The maximum constant current is 2 amperes per channel.
Please reduce load if main unit is overheating.
CAUTION! Do not short circuit or overload the LED outputs,
this may lead to permanent damage!
Operation
1.Using Remote Controller
Please pull out the battery insulate tape before using. The RF
wireless remote signal can pass through barrier, so it's not
necessary to aim at the main unit when operate.
For proper receiving remote signal. please do not install the
main unit in closed metal parts.
2.Pairing New Remote
The remote and main unit is 1 to 1 palred as default. Further
more, main unit can be paired to 3 remote controllers and
each remote controller can be paired to any main unit.
Please do following steps to pair new remote controller:
1). Plug off the power of main unit and plug in after 5 seconds.
2). Press "SPEED-' and "SPEED+'key topether in 5 second
safter power on.
After this operation, the main unit will recognize the new
remote controller.
Installing
1.Power Supply
This unit accepts DC 5V to 24V power supply. The DC jack's
inner pole (or red cable) is positive and sleeve (or black cable)
is negative. Also please make sure the power supply voltage is
same as the LED load.
2.LED Output
This unit support common anode connection LED products.
The mark' 'indicates the common connection node.
+
3.Free Remote Pairing Mode
In some specific cases, the main unit may need to be paired
to any remote controllers. Please do following steps for free
remote pairing mode:
1). Plug off the power of maln unit and plug in after 5 seconds
2) Press "ON/OFF and MODE+' key together in 5 seconds
after power on.
After this operation, the main unit will recognize any
remote controller To pair the main unit back to specific
remote, please repeat the "Pairing New Remote' operation.
4.Switch Output Color Sequence
The controller's default output sienal sequence is
Common-Green-RedBlue. If the LED application is in different
cable sequence the direct color keys will not match the LED
color. in this case user can adjust the output slgnal sequence
with followine steps:
1). Plue off the power of main unit and plug in after 5 seconds
2) Press "RED'and "BLUE' color key torether in 5 seconds after
power on.
With this operation, the output sequence will switch between
6 possible combinatlons. The sequence wil be memorized
and it won't change before next same operation.
10/11
①
⑥
②
MODE
+
⑦
③
DEMO
SPEED
_
SPEED
+
⑧
⑨
MODE
_
⑩
④
COLOR
BRIGHT
+
+
11
WHITE
⑤
BRIGHT
12
COLOR
_
_
Advertisement
