Advertisement
INSTALLATION
Transit devices
All transit bolts and packing must be removed before
using the appliance.
Proceed as follows:
Using a spanner,
un-
screw and remove the
rear right-hand bolt and
lay the machine on its
back, taking care not to
squash the hoses. This
can be avoided by plac-
ing one
of the corner
packing pieces between
the machine
and
the
Remove the polystyrene blocks from the underside of
the machine and release the two plastic bags by
removing the adhesive strip.
Carefully remove the right-hand bag (1) then the left-
hand bag (2) by pulling them towards the centre of the
_machine.
Set the machine upright and remove the two remain-
ing bolts from the back.
Pull out the three plastic pegs from the holes into
which the bolts were fitted.
Plug the open holes with the plugs which you will find
at the back of the appliance.
Note: You are advised to keep all transit devices so
that they can be refitted if the machine ever has to be
transported again.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine i
not impeded by carpets, rugs etc. Check that ing
machine does not touch the wall or other kitche
units.
Carefully level by screwing the adjustable feet in o|
out. Never place cardboard, wood or similar material
under the machine to compensate for any uneven}
ness in the floor.
After having levelled the machine, tighten the lock
nuts.
Water inlet
Connect the water inlet hose to a tap with a 3/4]
thread after having inserted the small filter "A" sup}
plied with the machine.
The inlet hose must not be lengthened. If it is too sho
and you do not wish to move the tap, you will have "
purchase a new, longer hose specially designed fo
this type of use.
The other end of the inlet hose which connects to a
machine can be turned in any direction. Simply loose!
the fitting, rotate the hose and retighten the fitting
making sure there are no water leaks.
25
x
"
wal
So
2
i
Advertisement
