GE 21 Owner's Manual And Installation Instructions page 4

About the controls with temperature settings.
(on some models)
[] TEMPERATURE SET
WARMER _ WARNER
Ico'° R
rE O_ F R_°mmended 37_ F Rec°mmended
[]
[] []
EZ]
Hold 3 seconds to reset Hold 3 seconds
(on some models)
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
The temperature controls ore preset in the factory at 37°F for the refrigerator
comportment and O°F for the freezer comportment. Allow 2/4 hours for the temperature
to stabilize to the preset recommended settings.
The temperature controls con disptoy both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly
from the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
comportments, but does not shut off electrical power to the refrigerator.
4
Changing the Temperature
For Controls-on-the-Door Models:
To change the temperature, press and release the
WARNERor COLDERpod. The ACTUALTENP light
will come on and the displuUwill show the actual
temperature. To change the temperature, tap either
the WARNERor COLDERpad until the desired
temperature is displayed.
For Controls Inside the Refrigerator:
Opening the door displogs the actual temperature. To
change the temperature, press either the WARNERor
COLDERtouch pads until the desired temperature is
displayed.
Once the desired temperature has been set,
the temperature displag will return to the actual
refrigerator and freezer temperatures after 5
seconds. Severaladjustments mog be required. Each
time gou adjust controls, allow 24 hours for the
refrigerator to reach the temperature gou have set.
To turn the cooling system off,,top the WARNERpad
for either the refrigerator or the freezer until the
displug shows OFF.To turn the unit back on, press
the COLDERpod for either the refrigerator or freezer.
Then press the COLDERpad again and it will go to
the preset points of O°Ffor the freezer and 37°Ffor
the refrigerator. Setting either or both controls
to OFF stops cooling in both the freezer and
refrigerator compartments, but does not shut
off electrical power to the refrigerator.