Camera Connection; Installing The Microphone; Speaker Connection - Sony XAV-AX8500 Operating Instructions Manual

Camera Connection

Installation of cameras (not supplied) is required
before use.
Connect the camera power cord (lead) to the
accessory power terminal.
When connecting the iDataLink Maestro module
(not supplied) and you are using the Backup
Camera Dynamic Guidelines function, adjust the
guideline.
 2.0 m (6
1 / feet) behind the car
2
 0.5 m (1
3 / feet) behind the car
4
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.

Speaker connection

• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
14
EN

Installing the microphone

To capture your voice during handsfree calling, you
need to install the microphone .

Clip (not supplied)
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base  to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Installing the GPS antenna (aerial)
• Choose a location where no obstacle blocks GPS
satellite reception so as to achieve the best
reception.
• Make sure the GPS antenna (aerial)  does not
interfere with the operation of car equipment.
• Some types of front windshields (windscreens)
block GPS satellite radio waves. Make sure the
signal reception is not blocked.
• When using Apple CarPlay with a wireless
connection, make sure the GPS antenna (aerial) 
is connected.


