Connecting Rear View Camera; Listening To The Radio - Sony XAV-AX3005DB Operating Instructions Manual

Connecting with a paired BLUETOOTH
device
To use a paired device, connection with this unit is
required. Some paired devices will connect
automatically.
1
Press HOME, then touch [Settings].
2
Touch [Bluetooth].
3
Touch [Bluetooth Connection], then touch
[ON].
Make sure that lights up on the status bar of
the unit.
4
Activate the BLUETOOTH function on the
BLUETOOTH device.
5
Operate the BLUETOOTH device to connect
to this unit.
or lights up on the status bar.
To connect the last-connected device from
this unit
When the ignition is turned to on with the
BLUETOOTH signal activated, this unit searches for
the last-connected BLUETOOTH device, and
connection is made automatically.
Note
While streaming BLUETOOTH audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead.
To install the microphone
For details, see "Installing the microphone"
(page 28).

Connecting Rear View Camera

By connecting the optional rear view camera to the
CAMERA IN terminal, you can display the picture
from the rear view camera. For details, see
"Connection/Installation" (page 25).
To display the picture from the rear view
camera
Press HOME, touch [Rear Camera].
8
GB

Listening to the Radio

Listening to the Radio
To listen to the radio, press HOME then touch
[Tuner].
Reception controls/indications
 Current band
Change the band (FM1, FM2, FM3, AM1 or AM2).
 Current frequency, program service name*,
RDS (Radio Data System) indication*
* During RDS reception.

(tuner option)
Open the tuner option menu.
 SEEK-/SEEK+
Tune in automatically.

/
Tune in manually.
Touch and hold to continuously skip
frequencies.
 Preset numbers
Select a preset station. Swipe right/left to show
the other preset stations.
Touch and hold to store the current frequency in
that preset.
Tuning
1
Select the desired band (FM1, FM2, FM3,
AM1 or AM2).
2
Perform tuning.
To tune automatically
Touch SEEK-/SEEK+.
Scanning stops when the unit receives a station.
To tune manually
Touch and hold /
frequency, then touch
adjust to the desired frequency.
to locate the approximate
/ repeatedly to finely