Important Safety Instructions - Philips NORELCO QP6510 Quick Start Manual

English

IMPORTANT SAFETY INSTRUCTIONS

When using an electric product, basic
precautions should always be followed,
including the following:
Read all instructions before using this
product.
DANGER
To reduce the risk of electric shock:
- Do not reach for a corded product that has
fallen into water. Unplug immediately from
the power outlet.
- The power cord and the accessories
connected to it are not for immersion or for
use in shower.
- Do not use an extension cord with this
product.
- Do not place or store the product where it
can fall or be pulled into a tub or sink. Do
not place or drop the product into water or
other liquid.
- Always unplug this product from the
electrical outlet immediately after
(re)charging.
- Remove power cord from power outlet and
product before cleaning.
- The batteries used in this product may
present a fire or chemical burn hazard if
mistreated. Do not disassemble, heat above
100 °C (212 °F) or incinerate.
WARNING
To reduce the risk of burns, fire, electric
shock, or injury to persons:
- Close supervision is required when this
product is used by, on, or near children, or
persons with limited physical, sensory, or
mental capabilities or invalids.
- Use this product only for its intended
household use as described in this manual.
Do not use attachments not recommended
by Philips North America LLC.
- Never operate this product if it has a
damaged power cord, if it is not working
properly, if it has been dropped or
damaged, or dropped into water while
plugged in. For assistance call
1-800-243-3050.
- Keep the power cord away from heated
surfaces.
- Never drop or insert any object into any
opening.
- Do not use the adapter in or near a power
outlet that contains an electric air freshener
to prevent damage to the adapter.
- Do not charge, clean or plug in product
outdoors or operate where aerosol (spray)
products are being used or where oxygen is
being administered.
- Always check cutters, cutting unit and
guards before using the product. Do not
use the product if cutters, cutting unit or
guards are damaged, as injury may occur.
- Always attach power cord to product first,
then to power outlet. Be certain plug is
inserted firmly into product up to mark
indicated on plug. To disconnect, turn
product off then remove power cord from
outlet.
- Keep the power cord dry at all times. Do
not handle with wet hands.