Table of Contents
Advertisement
3. PIN DEFINITION
3.1 CL_CMOS
CL_CMOS is the CMOS clear jumper, using a 1x2 pin with a 2.0mm pitch.
RTC1
Close
Open
3.2 AT/ATX
AT/ATX is the jumper for selecting the power-on mode. When Pins 1-2 are closed, upon
powering up the supply, the board is on.
Pin 1-2, Close; Pin 2-3, Open
Pin 2-3, Close; Pin 1-2, Open
3.3 FP1
FP1 is the controller board interface, adopts 2x5Pin with 2mm pitch. Pin definition is shown
below:
F_PANEL1
1,3
2, 4
5, 7
6, 8
9, 10
Jumper Selection
Hard flash drive read/write indicator positive and negative signal pin
Main power indicator positive and negative signal pin
Main board reset signal positive and negative pin
Main board power on/off signal positive and negative pin
Functions
Clear RTC CMOS
Default setting
AT power-on mode
AT power-on mode
Pin Definition
Buzzer interface
8
13.3inch e-Paper (K)
User Manual
Power-on Mode
Advertisement
Table of Contents
