Viking DUC180 Installation Instructions page 4

I I n n s s t t a a l l l l i i n n g g C C u u s s t t o o m m F F r r o o n n t t ( ( D D F F C C m m o o d d e e l l s s o o n n l l y y ) )
1. Prepare custom front panel and handle. (See information on p. 4 for details/dimensions.)
2. Placed prepared custom front panel on the ledge of the unit. (See Illustration #1).
3. Attach to unit by placing two (2) #10 x 1/2" screws in the lower most holes and screwing through the pilot holes on the
overlay. (See illustration #2). Loosen screws and center panel if needed. Retighten lower most screws after adjusting.
I I l l l l u u s s t t r r a a t t i i o o n n # # 1 1
I I l l l l u u s s t t r r a a t t i i o o n n # # 2 2
Ledge for panel
4. Secure the overlay panel by using the remaining seventeen (17) #10 x 1/2 screws. (See illustration #3).
5. Install the storage compartment cover with two (2) #8 x 3/8" wafer head screws. (See Illustration #4).
I I l l l l u u s s t t r r a a t t i i o o n n # # 4 4
I I l l l l u u s s t t r r a a t t i i o o n n # # 3 3
5