Stihl MS 210 Instruction Manual page 52

English
Installing the Rope Rotor
Standard versions
7
8
9
Coat the rope rotor bearing bore
N
with non-resinous oil.
Slip the rotor over the starter post –
N
turn it back and forth to engage the
anchor loop of the rewind spring.
Refit the pawl (9) in the rotor.
N
Fit the washer (8) on the starter
N
post.
Use a screwdriver or suitable pliers
N
to install the spring clip (7) on the
starter post and engage it on the
pawl's peg – the spring clip must
point clockwise as shown in the
illustration.
50
Versions with Easy2Start
7
8
9
9
Coat the rope rotor bearing bore
N
with non-resinous oil.
Slip the rotor over the starter post –
N
turn it back and forth to engage the
anchor loop of the rewind spring.
Refit the pawls (9) in the rotor.
N
Fit the washer (8) on the starter
N
post.
Use a screwdriver or suitable pliers
N
to install the spring clip (7) on the
starter post and engage it on the
pawl's peg – the spring clip must
point clockwise as shown in the
illustration.
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
Tensioning the Rewind Spring
Make a loop in the starter rope and
N
use it to turn the rope rotor six full
revolutions in the direction of the
arrow.
Hold the rotor steady. Pull out and
N
straighten the twisted rope.
Release the rope rotor.
N
Release the rope slowly so that it
N
winds onto the rotor.
The starter grip must sit firmly in the rope
bushing. If the grip droops to one side:
Add one more turn on the rope rotor to
increase spring tension.