Table of Contents
Advertisement
PVM-20M7MDE
8. NTSC Y/C Color Level Adjustment
Connect
the
input signal to the LINE B connector.
(A) NTSC Y/C R-Y, DAI
l. Input
the
NTSC 100% color bar signal.
2. Perform the same adjustment as sect.ion VI-3-(B) using
~
NTSC YIC R-Y PAl
3. Writethedata.
(B)
NTSCY/CY.DA1
I. Input the NTSC 100% color bar signal.
2.
Perform the same
adjustment as section VI-3-(C) using
~
NTSCYICY DA1
3. Writethedata.
(C)
NTSCY/CB-Y.DAl
1. Input the NTSC 100% color bar signal.
2.
Perfonn
the same adjustment as
section
VI -3-(D)
using
~
NTSCY/CB-Y DAJ
3.
Writethedata.
9. Component Color Level Adjustment-1 (N10/SMPTE)
Connect the input signal
to
the ROB A or ROB B connector.
(A) Component N10 R-Y. DAl
1. Input thecomponent(NIO/SMPTEle~) 100% color bar signal
2.
Perfonn
the
same adjustment
as
section
VI-3-(B)
using
~
COMP N10 R-Y DAl
3.
Writethedata.
(B) Component NIO Y. DAI
1.
Input
the component (NlO/SMPfElevel) 100% color bar signal.
2, Perfonn the same adjustment as section
VI-3-(C)
using
im..1'!l!..ill
COMPNlOY DA1
3. Wdtetbedata.
(C) ComponentNIOB-Y.DAl
1. Input the component (NlO/SMPTElevcl) 100% color bar
signal.
2. Perfonn the
same
adjustment as section VI-3-(D) using
~
COMP NJO B-Y DAI
3. Writethedata.
1 O. Component Color Level AdJustment-2 (Betacam)
Connect the input signal
to
the ROB A
or
RGB B connector.
(A) ComponentBetacamR-Y.DAl
I. Input the component (Beta.cam
level)
JOO% color bar signal.
2. Perform the same adjustment as section VI-3-(B) using
~
COMPBETA R·Y DAI
3. Writethedata
{B) ComponentBetacam B-Y. DA]
I. Input the component (Bera.cam level) 100% color bar signal.
2. Perform
the
same adjustment as section VI-3-(D) using
~
COMPBETAB-Y DAI
3. Writethedata.
11. RGB Color Level Adjustment
Connect the
input
signal
to
the ROB A or ROBB connector.
(A) KGB R-Y. DA!
1.
Input the ROB IOO%colorbarsignal.
2. ConnectanoscilioscopetoTPl6RlR:X-
3.
Entertheservicemode(.uem....Nu...lf
4. Adjust~
until amplitude of the wavefonn is
1.4V±50mVp-p.
5.
Wriiethedata.
~,-~~~;:~~p-p
----T-
Note: If sync is added
to
the signal, amplitude can be
adjusted
for
2V±50m Vp-p including sync.
-40-
Advertisement
Table of Contents
