Safety Instructions For The Engine - Bison 130 Owner's Manual

NOTE:
Before using the pressure washer to clean patio paving slabs it is advisable to test a small area first,
some paving slabs are manufactured from inferior materials and the use of a pressure washer could
damage the surface.
USING THE DETERGENT FACILITY (Fig. 26)
Fill a suitable container with pressure water detergent. Do not use washing up liquid as it contains salt. We
recommend the use of good quality pressure washe「 detergent for use with this pressure washe「.Please follow
the instructions on the container. Most automobile detergents are a combination of a detergent and a wax
solution. The viscosity (thickness) of the detergent will increase in cold weather. It is recommended that this type
of detergent is diluted with water before filling the container. When using combination wash and wax solutions we
recommend that they are diluted before use. As a general guide we would recommend a dilution rate of 50/50.
However a trial and error process would determine the ideal dilution rate for a particular detergent
NOTES:
A thick viscous detergent would not flow freely from the detergent tank and the residue would cause a blockage
flow system. After using the detergent facility it should be flushed thoroughly using copious amount of water. To
activate detergent delivery, fit the Black LOW PRESSURE nozzle to the and of the lance. Submerge the and of
the detergent pick up pipe into your container of pressure water detergent. Suction and mixing will occur
automatically as the water flows though the pump.
-
•
FIG.26
=--
,,
3
｀
一
、 , . 、.
磕－
CLEARING A BLOCKAGE (Fig. 27)
If at any time the flow rate stutters or is inconsistent, release the trigger and switch OFF the machine.
Squeeze the trigger to relieve any pressure and check the jet in the end of the lance for any blockage.
If a blockage is suspected use some wire to clean the inside of the nozzle.

SAFETY INSTRUCTIONS FOR THE ENGINE

1. Before operating the engine, be sure to read all instructions carefully as injury or permanent damage to
equipment may occur.
2.Run the engine in a well ventilated area.
3.Ensure the appliance is at least one metre away from building walls or other equipment.
4.Keep the appliance away from flammable liquids such as petrol
5.Refuel in a well ventilated area with the engine switched off and avoid sparks or naked flames
6.When refuelling ensure that you do not overfill the fuel tank.
7.lf any fuel is spilled ensure it is deaned up thoroughly before restarting.
8.Ensure the fuel cap Is located securely.
9.The exhaust mufflers get very hot and will remain hot for sometime after the engine is switched off.
1 a.Ensure the appliance is cooled before transporting or storing.
｀
9
...
FIG. 27
-7-