Inateck BCST-70 Configuration

Hide thumbs Also See for BCST-70:

https://wiki.teltonika-gps.com/view/Inateck_BCST-70_Configuration

Main Page

Accessories

Contents

1 Configure FM device using Teltonika configurator

Configure FM device using Teltonika configurator

In System settings, enable Codec8 Extended

In GPRS settings, configure GPRS Settings and Server Settings.

In Bluetooth settings,

Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)",

otherwise Bluetooth will be disabled

Under Bluetooth Control, click Discover so it would detect devices within vicinity.

Once devices are discovered, select BCST-70-XXXX-SPP then proceed to tick Pair

After successful pairing, scanner should show under Paired Devices.

NOTE:

: If in case the Scanner is not discovered, do the following steps on Bluetooth Pairing.

Enable Bluetooth Pairing

Scan "Enter Setup"

Inateck BCST-70 Barcode Scanner

> Inateck BCST-70 Configuration

Table of Contents

Do you have a question about the BCST-70 and is the answer not in the manual?

Page 1 Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)", otherwise Bluetooth will be disabled Under Bluetooth Control, click Discover so it would detect devices within vicinity. Once devices are discovered, select BCST-70-XXXX-SPP then proceed to tick Pair After successful pairing, scanner should show under Paired Devices. NOTE: : If in case the Scanner is not discovered, do the following steps on Bluetooth Pairing.
Page 2 Scanner Auto Connect Configuration Fill up the “Auto Connect To External Device“ with as follows: Select Connection Mode as, Inateck Scanner. Enter the External MAC, can be seen on Paired Devices at the upper left corner. Enter the External Name, can be seen on Paired Devices at the lower right corner.