Sears Kenmore 89682 Owner's Manual page 6

Removing and Replacing
the Microwave uven
If you need to remove your Microwave Hood
Combination for any reason, follow these simple
steps:
To remove:
1. Unplug microwave oven or disconnect power.
2. Remove filtersand
vent gdlle.
• If filters A are
installed, push in at
_ the tab and slide
filterto the outside
edge to remove.
• Remove the two
screws B from
the top of the
microwaveoven
cabinet (the screws located closest to the front
comers). Do not remove the screws located
towards the center of the cabinet.
• Remove the vent grille C. Set the screws and
gdlle aside. (If gdlle cannot be removed, see
Step 4.)
3. After removing all
oven contents,
includingthe
turntable and
support, tape the
door in the closed
position.Then
remove the two
belts D securing
the microwave oven
to the upper
cabinet.
4. Hold microwave
hood combination in
place with one hand.
Pull hook E to release
microwave hood from
mounting plate. If grille
cannot be removed
(see Step 2), insert a
thin looped wire or
similar tool through an
opening in grille to
pull hook.
5. Grasp the microwave
oven cabinet. Rotate
the microwave oven
downward. (Be careful
that door does not
swing open.)
6. Lift Offthe support
tabs F at the bottom
of the mounting plate.
Set the microwave
oven aside on a
protected surface.