Sony CDP-CE375 Operating Instructions Manual page 7

Making digital hookups
If you have a digital component such as a
digital amplifier, D/A converter, DAT, or MD,
connect the component via the DIGITAL OUT
(OPTICAL) connector using the optical cable
(not supplied). Take offd_e cap and plug in the
optical cable.
Note that you cannot use the fbllowing
_hnctions when making this connection:
• Fading In or Out (see page 12)
• Adjusting the output level using the
ANALOG OUT LEVEL +/ buttons on the
remote
POC-15
Optical cable {not supplied)
CD player Digital component
INPUT
Note
When you connect via the DIGITAL OUT
(OPTICAL) connector, noise m_y occur when you
play CD sot_ware olher than music, such as a CD-
ROM.
Transporting the player
Before transporting the player, tbllow the
procedure below to relurn the internal
mechanisms back to their original position.
1 Remove all the discs from the disc tray.
2 Press _ OPEN/CLOSE to close the
disc tray.
"no dISC'" appears in the display.
3 Wait for 10 seconds, then press
POWER to turn off the player.
1 Turn on the amplifier and select the CD
player position so that you can listen to
the sound from this player.
2 Press POWER to turn on the player.
3 Press _OPEN/CLOSE.
The disc compartment slides out.
4
Place a disc on the disc tray with the
label side up.
Disc number
When you play a CD single,
place it on the inner circle
of the tray.
S To place other discs, press DISC SKIP
and place the discs in the order you
want to play,
Each time you press d_e button, the disc tray
turns and you can place the discs in the
empty disc compartments. The player plays
the disc in front of you first.
6 Press _OPEN/CLOSE to close the disc
compartment.