Download Print this page

Viking E-10 Technical Practice page 3

Speaker phones
Hide thumbs Also See for E-10:

Advertisement

B. Mounting the E-20A and E-20A-EWP
The E-20A and E-20A-EWP are designed to be surface mounted to a single gang box (not included), a standard 4" x
4" electrical junction box (not included), or directly to a wall or flat sided post.
3.40"
1.55"
3.40"
2.35"
C. Wiring the E-10 and E-10-EWP
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC outlet and the telephone line. It is recommended
!
that a surge protector be installed to protect against such surges. Contact Panamax at (800) 472-5555 or Electronic Specialists Inc. at (800) 225-4876.
Rear View of the
E-10/E-10-EWP
(Spade
connector
included)
** Earth
Ground
(optional)
***** Drip Loop
(optional)
D. Wiring the E-20A and E-20A-EWP
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC outlet and the telephone line. It is recommended
!
that a surge protector be installed to protect against such surges. Contact Panamax at (800) 472-5555 or Electronic Specialists Inc. at (800) 225-4876.
Rear View of the
E-20A/E-20A-EWP
***** Drip Loop
(optional)
* Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 guage wire with a maximum insulation of 0.082
inches. Do not strip wires prior to terminating.
** Note: To increase surge protection, loosen the PCB mounting screw labeled
ed) from the mounting screw to Earth Ground (grounding rod, water pipe, etc.)
*** Note: Talk battery must be a minimum of 28V DC when using the speaker phone with a Viking Hot-Line Dialer. For more information on Hot-Line
Dialers, retrieve Fax Back Documents 317.
**** Note: When installing a line powered phone on a low voltage and/or low loop current phone system extension, a PS-2R Talk Battery/Loop Current
boosting power supply may be required. For more information on the PS-2R, retrieve Fax Back Documents 512.
***** Note: When wires are routed from above, a "drip loop" is recommended to keep water away from the circuit board.
Front view of the
E-20A and E-20A-EWP
3.30"
VIKING
©
To open the speaker box, remove
the two screws from the cover.
*Gel-Filled Butt
Connectors
(EWP Only)
Red
(Ring)
Green (Tip)
-or-
** Earth Ground
(optional)
(Spade connector
included)
* Gel-Filled Butt
Connectors
(EWP Only)
Red
(Ring)
Green (Tip)
-or-
Back panel of the
E-20A and E-20A-EWP
UP
Call
Mount back panel to a wall, a single
gang box or a 4"x4" junction box with
the arrow pointing up. Note: For outdoor
applications apply a bead of caulk
between back panel and wall.
*** Optional
Viking Dialer
C.O. Line
(not included)
or analog
PABX/KSU
analog PABX/KSU
VIKING
station
©
station programmed
Programmable
Tone Dialer
MODEL: K-1900-5
Quick Programming Guide
1. Call the phone connected to the dialer.
2. Answer phone. Enter
& security code.
(Factory set to 845464) Write your
security code below:
3. Enter your spped dial number & #00.
Note: For additional programming see
K-1900-5 Technical Practice.
Viking Electronics, Inc.
Hudson, WI 54016
LINE IN
PHONE
-or-
*** Optional
Viking Dialer
C.O. Line
(not included)
or analog
PABX/KSU
analog PABX/KSU
VIKING
station
©
Programmable
station programmed
Tone Dialer
MODEL: K-1900-5
Quick Programming Guide
1. Call the phone connected to the dialer.
2. Answer phone. Enter
& security code.
(Factory set to 845464) Write your
security code below:
3. Enter your spped dial number & #00.
Note: For additional programming see
K-1900-5 Technical Practice.
Viking Electronics, Inc.
Hudson, WI 54016
LINE IN
PHONE
-or-
(as shown above) and fasten a wire with spade terminal (includ-
Side view of the
E-20A and E-20A-EWP
Attach the cover to the base
with the two included screws
as shown.
Need More Information on the DLE-200B?
?
Call (715) 386-4345 and select 605.
**** C.O. Line or
DLE-200B Two Way Ringdown
Circuit (not included)
for ringdown
VIKING
DLE-200B
RES
BUSY
Need More Information on the DLE-200B?
?
Call (715) 386-4345 and select 605.
**** C.O. Line or
DLE-200B Two Way Ringdown
Circuit (not included)
for ringdown
VIKING
DLE-200B
RES
BUSY
RINGDOWN
©
1
2
To dedicated
phone or unused
trunk/line input
of phone system
RINGDOWN
©
1
2
To dedicated
phone or unused
trunk/line input
of phone system

Advertisement

loading

This manual is also suitable for:

E-10-ewpE-20aE-20a-ewp