Table of Contents
Advertisement
OPERATING PROCEDURE
2. Removing the inverter assembly and inverter P.C. board
(1) Remove the cabinet and panels (refer to section 1).
(2) Disconnect the lead wire to the reactor and the following
connectors:
<Inverter P.C. board>
CN721 (R.V. coil)
CN931, CN932 (Fan motor)
CN641 (Defrost thermistor and discharge temperature
thermistor)
CN643 (Ambient temperature thermistor)
CN644 (Outdoor heat exchanger temperature thermistor)
CN724 (Expansion valve coil)
CN64 (Compressor protector)
(3) Remove the compressor connector (CN61).
(4) Remove the screws fixing the heat sink support and the
separator.
(5) Remove the fixing screw of the P.B. support and the separator.
(6) Remove the fixing screws of the terminal block support and
the back panel.
(7) Remove the inverter assembly.
(8) Remove the screws of the earth wires.
(9) Remove the heat sink support from the P.C. board support.
(10) Remove the screw of the inverter P.C. board and remove the
inverter P.C. board from the P.C. board support.
OBH832C
PHOTOS/FIGURES
Photo 3
Screw of the heat sink
support and the separator
Photo 4 (Inverter assembly)
Heat sink support
Heat sink
Inverter P.C. board
Screw of the inverter P.C. board
68
Screw of the P.B. support
and the separator
Screws of
the terminal block
support and
the back panel
P.C. board support
Screws of
the earth wire
Advertisement
Table of Contents
