Advertisement
HSIT9ONI
Selection of cassette tapes
Do not use the following types of tapes in this unit.
Cassette tapes exceeding 90 minutes
These tapes are handy for their long playback and recording time
but be careful about repeatedly stopping and starting, rewinding
and fast forwarding these tapes in short intervals as they are thin,
tend to stretch and may become
entangled in the machine.
eFe-Cr tapes (TYPE iil)
The high frequency range will be emphasized and it will not be
possible to obtain a flat frequency response.
Metal tape without detection holes in the cassette
Recordings will be very distorted. (There is no playback problem,
however.)
Metal tape
Detection holes
Tape slack
Tape slack may cause the tape to break.
Use a pencil or similar
object to take up the
slack.
To prevent erasure of recorded sounds
Remove the erase-prevention tabs (thus preventing recording).
Use a screwdriver
or similar object to
break out the tab.
Tab for side "B"
W To re-record on a protected
cassette
Cover the slot with adhesive tape.
Attach tape.
Avoid tape storage in the following
places
Tape can be damaged if it is stored in places such as described
below.
Where the temperature is high (95°F/35°C or higher) or where the
humidity is high (80% or higher).
Where there is a strong magnetic field (near a speaker, on top of
a TV, etc.). Recording may become erased.
ein direct suntight.
Advertisement
