Greenheck Vektor-MD Installation, Operation And Maintenance Manual page 4

®
READ THROUGH THESE INSTRUCTIONS PRIOR TO STARTING ASSEMBLY.
Use Document #1016009 with fastener kits 879430 and 879431. These kits are to be used with the Vektor-MD
model. The fasteners contained within the kit are to be used to attach the silencer to the Vektor-MD dilution style
nozzle, a silencer to the blower housing, or a silencer to a stack extension. Systems supplied with inline discharge
silencers always have the nozzle section ship separate. The silencer is installed between the fan housing and
nozzle. Use the images located within this document to locate the position of the fasteners on the unit.
Assembly Instructions
1. See Greenheck Document #464652 (Installation, Operation and
Maintenance Manual: Vektor-MD, Vektor-MH and Vektor-MS) for full
installation instructions.
2. The fastener kit includes fasteners for one fl ange. If the fan includes
stack extensions, multiple fastener kits will be supplied for each fl ange.
3. See image below to locate bolt holes. Install moly-coated 316 stainless
steel screws (provided).
Tools Required
• Cordless drill (electric or pneumatic)
• 1/2 inch nut setter
FASTENER KIT 879430 – VEKTOR-M SIZE 15-27
Part Description
CS,HH,.313-18X1,SS,316,MOLY,W/EPDM WSHR
Assembly Instructions
FASTENER KIT 879431 – VEKTOR-M SIZE 30-54
Part Description
CS,HH,.313-18X1,SS,316,MOLY,W/EPDM WSHR
Assembly Instructions
Phone: (715) 359-6171 • Fax: (715) 355-2399 • E-mail: vektor.support@greenheck.com • Website: www.greenheck.com
4 Fastener Kit • Inline Silencer, Rev. 1, February 2018 Vektor-M Series ERS Fastener Kits
Assembly Instructions
Document Instructions
8-16X per Flange
Part #
416511
1016009
Part #
416511
1016009
Vektor-M Series Fastener Kit
Laboratory Exhaust System
Quantity
8
1
Quantity
16
1
Copyright 2018 © Greenheck Fan Corp.
Document 1016009
Inline Silencer
Windband
Nozzle
Blower Housing
Bypass Air Plenum
Roof Curb or
Structural Support
® ®