Advertisement
Quick Links
Contents
1.
Lock body
2.
Long plate external furniture
3.
Long plate internal furniture
4 .
Cylinder (not included,
length to suit door thickness)
5.
Zinc spindles
6.
Furniture fixing screws
7.
Cylinder retaining screw
8.
Fixing tabs
Step 1: Door Preparation
1.1
For Flush Mount, route the door as per technical dimensions below
FLUSH MOUNT INSTALLATION
22.0
R2.5 x 4
5.0
2 HOLES
2 HOLES
Virtus Four Point Hinged Door Mortice Lock
Installation Guide
4.
5.
30mm BACKSET
30
9 x 2 HOLES
8.6 CSK
1.
2.
20
8
10
R10
3.
Austral Aurora furniture shown
6.
7.
40mm BACKSET
40
8.
60mm BACKSET
60
Advertisement
Related Manuals for Gainsborough Austral Lock Virtus Four Point Hinged Door Mortice Lock
Summary of Contents for Gainsborough Austral Lock Virtus Four Point Hinged Door Mortice Lock
- Page 1 Virtus Four Point Hinged Door Mortice Lock Installation Guide Contents Lock body Long plate external furniture Long plate internal furniture Cylinder (not included, length to suit door thickness) Zinc spindles Furniture fixing screws Cylinder retaining screw Fixing tabs Austral Aurora furniture shown Step 1: Door Preparation For Flush Mount, route the door as per technical dimensions below FLUSH MOUNT INSTALLATION...
- Page 2 Step 1: Door Preparation (cont.) For Face Mount, route the door as per technical dimensions below FACE MOUNT INSTALLATION 30mm BACKSET 40mm BACKSET 60mm BACKSET 40mm BS 30mm BS 60mm BS routing is 37.5mm routing is 27.5mm routing is 57.5mm TOP VIEW OF STILE from face from face...
- Page 3 Step 3: Mounting Accessories Insert the spindle into the square hub of the lock Insert the cylinder into the cylinder hole and secure with the cylinder retaining screw Mount the internal and external hardware onto the spindle and cylinder If using snib furniture, align snib arm to snib slot in lock body Secure furniture with supplied fixing screws...
- Page 4 Step 5: Shoot Bolt Assembly Cut the shoot bolts to the required length as per instructions below: • Measure the distances as shown • Use the formula below and cut the lengths (lengths include threaded end piece) Top Rod (TR) = Panel Height (PH) - Handle Centre (HC) -98mm Bottom Rod (BR) END OF ROD...