Riello MULTICOM 421 Quick Start Manual

INSTALLATION
1. Remove the cover of the UPS expansion slot by removing the two retaining screws.
2. Insert MultiCOM 302 in the slot.
3. Fix the cover provided using the screws previously removed.
4. Connect the PROFINET Gateway to the MultiCOM 302 using the cable provided with the device.
NOTE: if necessary, you can also use another cable realized in accordance with the specifications (see Connection cable
MultiCOM 302 ↔ PROFINET Gateway).
5. Connect the PROFINET Gateway to the PROFINET Network.
6. Connect the power cable and apply power.
C M COM 302 ↔ PROFINET G
ONNECTION CABLE ULTI
DB9 male connect RJ-45
PIN to PIN
↔
5 2
↔
9 3
↔
8 4
NOTE: Use a twisted pair to connect PIN #9 and #8 of DB9 to PIN #3 and #4 of RJ-45
DIN-
RAIL MOUNTING
To snap the gateway on, first press it downwards (1) to
compress the spring in the DIN-rail mechanism, then push
it against the DIN-rail as to make it snap on (2).
- 0MNACCMCAENQA -
ATEWAY
To snap the gateway off, push it downwards (1) and pull it out
from the DIN-rail (2), as to make it snap off from the DIN-rail.
4
QUICK START MULTICOM 421
For additional information, please download User Manual from manufacturer's website.
PRESENTATION
I
N THE BOX
MultiCOM 302 board PROFINET Gateway
E
XTERNAL VIEW
PROFINET Connector
Status LEDs
Reserved
MultiCOM 302 Connector
Power Connector
DIN-rail Connector
- 0MNACCMCAENQA -
Connection cable between MultiCOM 302
and PROFINET Gateway
1