Maintenance And Cleaning - KEKAI KTL500 Instruction Manual

MAINTENANCE AND CLEANING:

• Before maintenance and cleaning, gas heater supply must be turned off, the heater should be
cold.Don't attempt to clean the heater while it is in use.
• The heater should be checked annually by a qualified technician for safe operation and in order
todetect any faults.
• In case any faults are detected while in use, stop using the heater and contact your dealer for advice.
• Periodically clean the exterior and storage area of your heater to remove dust and fuzz build upon
thesurfaces of the ceramic components.
• Do not use abrasive products to clean the heater.
• Check the pilot light while it is operating. It should burn steadily. If it flickers or there is a yellow flame,
the heater should be checked to make sure it is properly functioning.
• In case any parts need replacement, they must be replaced only with parts from the original
manufacturer. The use of incorrect or substitute parts might be dangerous and will void any
warranty.When the heater is not in use, we recommend that it is covered, or kept in its carton to
minimize the accumulation of dirt that may occur.
STORAGE:
If you decide not to use the heater for an extended period of time please follow the instructions below:
• Close the cylinder valve and disconnect the regulator from the cylinder.
• Store the cylinder in a well-ventilated room away from flammable or explosive materials and
preferably outside your home. Never store cylinders in a cellar or attic.
• The heater must be stored in a dry place and protected from dust (even better,store it in its original
packaging)
13