Changing The Cylinder; Replacing The Gas Cylinder - KEKAI KTL500 Instruction Manual

Note: when lighting a new heater for the first time, it might be necessary to hold the control knob down
for longer time in order to allow gas to flow to the pilot.
Once the heater in on at the 1-LOW setting, turning the control knob to 2-MEDIUM or 3-HIGH
positionwill light the second and third panel respectively.
To turn off the heater, turn back the control knob to the OFF position and close the cylinder valve
fully(clockwise). The heater can only be turned off by closing the cylinder valve. It can not be turned
offby the control knob.

CHANGING THE CYLINDER:

Turn off the cylinder valve fully (clockwise) and allow the heater to fully cool before removing and
replacing the cylinder. Do not attempt to remove the regulator while the heater is still running.
PLACE OF GAS HEATING:
• This heater is designed to be placed on the floor and away from the walls. When using the
heater,always point it in the direction of the center of the room. Clear all combustible materials from the
vicinity of the heater.
• The appliance must be 0.5 meters away from the walls.
• The front of the unit must be clear of a minimum of 2 meters.

REPLACING THE GAS CYLINDER:

• Replacing the gas cylinder must be done in a non-flammable, well-ventilated room. The appliance is
stopped.
• Close the cylinder valve.
• Disconnect and remove the regulator from the cylinder.
• Replace the empty cylinder with a full gas cylinder, checking that the seal is in good condition and that
the hose is in good condition and is not bent or crushed or in contact with the hot surfaces of the unit.
• Gently open the cylinder valve and check for leaks (no leakage) with soapy water.
• In the event of leakage (bubbles) close the cylinder valve and eliminate leaks; If not call a qualified
technician.
11