Technical Specifications; Instructions For Installation - KEKAI KTL500 Instruction Manual

IN CASE OF GAS LEAK:
Immediately close the cylinder valve if gas odor is detected.
 Extinguish any naked flame.
 Do not try again to turn on the unit.
Do not touch any electrical switch.

 Do not use a telephone in your apartment / house.
 Contact the gas supplier or our after-sales service or our dealer and follow their instructions.

TECHNICAL SPECIFICATIONS:

Full gas model:
Gas: LPG (Liquid Petroleum Gas G 30
Gas pressure: 2,8 KPA
Category: 3B/P(30)
Nominal flow (Max): 4,2 kW - 306 g/h
Heat Range: 3 levels (4200W / 2750W /
1500W)

INSTRUCTIONS FOR INSTALLATION:

 Remove the appliance from its packaging.
 Mount the different parts of the appliance according to the illustrations in the appendix.
 Assemble the individual panels with the supplied screws.
Set the control knob to the (O) or OFF position.

Fit the gas hose with the appliance connection and tighten with a clamp.

 Use a regulator with a fixed setting of 28 to 30 mbar and a flow rate of 1000 to 1500g/h.
 Fit the other end of the special gas hose to the regulator outlet and tighten with a collar. The hose
must have a length of 0.50 to 1.00 mtr.
 Fit the regulator on the gas cylinder (10kg) and tighten it properly.
 Open the cylinder valve and check the seal with soapy water.
Heater Operation instructions:
Lighting instruction:
The heater can be regulated to three different settings: 1-LOW, 2-MEDIUM and 3-HIGH. Ignition mode:
piezo ignition.
• Open the valve on the heater cylinder 1 and 1/2 turns.
• Press down and turn the control knob to 1-LOW position and hold for 10 seconds.
• While still pressing down the pilot light, press once or twice on the ignition button until the pilot light (at
the bottom of the burner) ignites. Continue to hold the control knob down for 10-15 seconds
more.Release the button, and if the pilot flame goes out, repeat the above operation.
10