Wire Dressing; Lead Assy, Jumper Wire Dressing At A Board; Lead Assy, Jumper Wire Dressing At A Board (Only For Audio 6+6 Non Dsp Models); Wire Dressing At A And H2 Board - Sony TRINITRON KV-SZ252M50 Service Manual

2-1. Lead Assy, Jumper Wire Dressing at A board

W082
W077
P/N 1-923-512-11
W016
Keep Lead Assy, Jumpers
away from R121
CN905
T501
W010
C514
W084
Dress Lead Assy, Jumper far
away from C514 and T501
W065
No. Part No. Description
1 1-910-026-28 Lead Assy, Jumper
2 1-923-512-11 WIRE UL1007 AWG24 150MM ORG

2-3. Wire Dressing at A and H2 board

i) Insert and dress Conn Assy, 4P into hook.
Conn Assy, 7P
Insert Conn Assy,
4P into hook
SECTION 2

WIRE DRESSING

Dress both Lead Assy, Jumpers
along edge of shield case
P/N 1-910-026-28
Conn Assy,
5P YUV
Dress both Lead
Assy, Jumpers
around CN905, C903
and below Conn
Assy, 5P YUV
C903
Block Remark
W016-W084(1)
A(Var)
W077-W065(0)
A(Com) W082-W010(1)
Conn Assy, 4P
CN4110
CN4113
1
CN3102
CN2105
CAUTION :
1. Do not overpull the wires during dressing
--> avoid disconnection of wires.
2. Make sure wires are kept away from
sharp edges, heatsinks & other
high-temperature parts.
2-2. Lead Assy, Jumper Wire Dressing at A board
(only for Audio 6+6 Non DSP models)
Dress Lead Assy,
Jumper around C249
P/N 1-910-036-25
Dress Lead Assy, Jumper in
between C211 and L2601
UL Tube
A003
Dress between
A003 and A002
No. Part No.
2 1-910-036-25
ii) Insert Conn Assy, 5P into CN4105.
Make sure AC Power Cord is behind Lead Assy,
Speaker at CN4106.
AC Power Cord is behind
Lear Assy, Speaker
TVSR:
Connector assy must be kept away
from primary area(10mm minimum).
– 7 –
KV-SZ252M50/M61/M81/N50/N60
W075
L2601
C211
A002
W085
Description Block
Lead Assy, Jumper A(Var) W075-W085(1)
Lead Assy, Speaker
CN4105
CN4106
Conn Assy, 5P
RM-GA002
Remark
2