Table of Contents
Advertisement
Adjust the attachment position and record
When using for the first time, be sure to adjust the 3D Conversion Lens attachment position.
Change the mode to
●
1
Attach the 3D Conversion Lens to the
video camera.
2
Turn on the video camera.
Turn on with the video camera in a horizontal state.
●
The 3D Conversion Lens adjustment mode screen
●
will appear automatically after performing the initial
setting.
If the 3D Conversion Lens adjustment mode
●
screen does not appear automatically, set from
the menu on the video camera.
([SETUP]
[3D CONV. LENS SETUP])
5
Open the adjustment dial cover.
When turning the adjustment dials, hold the video
●
camera in the palm of your hand from the bottom and
operate with the fingers of your other hand without
applying too much force from above. When checking
the adjustment, check with your fingers off the
adjustment dials.
.
on the video camera
3
●
●
4
●
●
6
The black vertical line may look thick or blurred, but
●
adjust it so it goes in between the guidelines.
Touch [NEXT].
●
4
Attach the lens front cap to the 3D
Conversion Lens.
Guide Line
2 screens will appear.
The horizontal line for adjustment on the lens front
cap is displayed on the screen.
Touch [ADJUST].
If the black vertical line and the black horizontal line
are within the red guidelines
required, touch [EXIT] and proceed to Step 11.
Perform the adjustment in a bright location where the
horizontal line for adjustment will be clearly visible.
(After checking the operation description, touch
[NEXT].)
Adjust the horizontal position by
rotating the horizontal image position
adjustment dial
to place the black
vertical line between the images at right
and left in between the red guidelines
and adjustment is not
.
Advertisement
Table of Contents
