Advertisement
Step 9
Attach the Front Cross Brace Assembly (08,09) to the Front Support Tube RH & LH (02) using
2 off the Small Round U Bolts (12) M10(25T) x 26(W) x 47(L). Preferred location is
approximately middle of top 2 bungee cords position. Adjust the V-tube Front cross brace
(08) to suit the required gap as per boat width then place the SS Bolts (13) into available hole
on both side and tightened the Nylon nut (13).
Maxwell and Higgs Pty Ltd provides a three-year warranty from the date of purchase against
defects in materials and workmanship. If the product is found to be defective , the product
will be repaired or replaced at our discretion. This warranty excludes product alterations,
misuse, or improper installation, and does not cover incidental or consequential damages.
For warranty service, return the product with proof of purchase to the address listed in this
manual.
08
D600
DSG045
09
9
Advertisement
