Kenwood TM-241A Instruction Manual page 39

4. 5੬੧ the second digit with the tuning control, then
press the MHz/LOCK key.
The third digit will flash.
5. Set the third and fourth digits. When the fourth digit
has been set, the DRS setting mode will be
automatically reentered.
С) The digits can be set with the MC-A4DM (option).
Perform steps 1 and 2, and key in the number with
the numeric keys.
Each time a key is pressed, a digit is set. When all the
digits have been set, the frequency will be displayed
again.
5-9-9 Setting the ОТМЕ Contro! Mode
1. Select the receive frequency.
2. Enter the DRS setting mode, and specify the number
of phrases, sound level, and ID number. (See Sections
5-9-1/2, 5-9-5, and 5-9-8.)
3. While in this state, press the F key for longer than 1
second, then press the DR/DT key while the F indica-
tor is flashing. The frequency will be displayed again
and the DRS indicator will flash.
укра
1- DOD
Press the key for longer than
1 second.
4. Press the F key. The DRS indicator will stop flashing
and stay on. The transceiver will be ready to be con-
trolled remotely.
The automatic recording mode will be ignored, as will
the DTSS and paging modes.
5-9-10 External Control Method
For external control, recognition code # or * will
transmit a four-digit ID number and three-digit
command code.
Leading zeroes in the ID number can be omitted.
@List of DTMF commands
See next page
———À
Note:
To transmit a DTMF signal, press a key within five
seconds of pressing the preceding key. If there is a
time delay of longer than five seconds, the DTMF
signals that have been transmitted will be cleared. |
39