Kenwood TM-241A Instruction Manual page 33

5-8-4 Using the DTSS function
1. Adjust the SQL control to the threshold point.
2. Press the DR/DT key. The DTSS indicator will light.
Each time the DR/DT key is pressed, the DTSS and
paging functions will be selected:
DTSS: OFF | DTSS :ON
—»- | PAGING:OFF > | PAGING : OFF
jOTSS : OFF
PAGING :ON
P indicator
lights.
@ RECEPTION
© TRANSMISSION
4. When the PTT switch is pressed, the code shown in
the figure is sent out for about 0.5 second.
PTT ON PTT OFF
Y Y
- 41.
94 Code (Approx.
0.5 seconds)
|
5. To cancel the DTSS function press the DR/DT key
twice time.
5-8-5
@ Delay during DTSS output
A delay is built in when the DTSS is sent out.
The delay time for normal transmission is 250 ms (not
modifable). |
The initial setting for shift, split channel, and duplex
is 450 ms, and can be changed to 750, 850, ог 1000
ms.
@ Changing the delay time
1. Turn DTSS mode on.
2. To change delay time press the F key for longer than
1 second and press the CALL key while the F indicator
is flashing.( within the 10 seconds.)
Using DTSS with a repeater
"4.
3. Display the desired delay time with the tuning
control or the UP/DWN key on the microphone.
The displayed delay time takes effect immediately. If
any other key is pressed or if, after 10 seconds, no key
has been pressed, the delay time setting mode is ter-
minated.
33