Safety Warning - ROTOR ALDHU ROAD Assembly Manual

#5.2 Secure the preload nut by tightening clockwise the preload bolt with a
2 mm Allen key.
If the crankset does not rotate smoothly, remove a 0.5 mm plastic washer
from the non drive-side and repeat the assembly adjustment steps #5.1 and
#5.2.
If there is lateral play, add an additional 0.5 mm plastic washer on the non
drive-side.
Ensure that the preload nut is still tightening on the non drive-side crank
arm.
This owners manual contains important and useful information regarding the proper installation, operation,
care, and maintenance of your ROTOR product. Carefully read, follow and understand the instructions as
detailed in this owner's manual. Keep this manual in a safe place for future reference.
.If you have any doubt whatsoever regarding your ability to install or service this product, please consult your
ROTOR dealer and seek the assistance of a professional bicycle mechanic. Do not perform any
modifications or adjustments that are not outlined in this manual.
Incorrect installation or servicing may impair performance, and could result in a dangerous situation leading
to serious injury or death.
Components that have experienced excessive wear, deformations or impacts or other damage need
immediate professional inspection or replacement.
Please have thisproduct regularly inspected by a qualified mechanic for any signs of wear or damage.
Failure to perform necessary and essential maintenance could drastically reduce the service life of your
ROTOR product and reduce its performance.
If you have any questions, please contact a professional bike mechanic or your nearest ROTOR dealer for
additional information.
Caution!: Please consult the relevant manufacturer's instruction manuals for your BB set or pedals, If
necessary,consult their technical service department for the correct installation procedure.
MAINTENANCE
Inspect your ROTOR product for wear, looseness or damage including cracks, dents and serious scratches,
before each ride and after every fall or crash. Do not use your ROTOR product until it has been thoroughly
inspected, repaired or replaced.
WARNING:
Continuing to use damaged parts may lead to loss of control and cause serious injury or death.
Cyclists should inspect their whole bicycle and parts on a regular basis or consult with aprofessional bicycle
mechanic, to determine the need for service, or replacement and to detect damage that may have occurred
from normal use.
Check all parts for damage and wear before every use. Check the bolts and other fasteners periodically for
tightness. Ensure they are tightened to the correct torque values.
ROTOR WARRANTY POLICY
- The ROTOR products and its components are guaranteed for 2 YEARS against any manufacturer defects or
defective materials. In the event ofa warranty defect, ROTOR´s sole obligation under this warranty is to repair
or replace, at its option, the defective part or product at no charge. Moreover, in some countries, ROTOR is
obliged to ensure any legal warranty defined by law for the customer's protection.
- Elements subject to wear and breakdowns that the manufacturer is not responsible for, are not covered by
this warranty.
- Failures or breakdowns caused by improper use, poor assembly or inadequate maintenance as declared in
the supplied instructions or the user manual are not covered by this warranty.
- Always keep your receipt or invoice.
- The following acts void this warranty:
- Failure to fulfil the requirements above.
- Improper installation.
- Improper use or installation of inadequate parts.
Warranty Service: Original purchaser must send their ROTOR product along with the retailer's original bill,
credit card receipt or other satisfactory proof of date of purchase of the product.
These instructions and others for ROTOR Bike Components products are available for download at:
ROTOR Componentes Tecnológicos SL - C/Miño, 14. 28864 AJALVIR MADRID SPAIN

SAFETY WARNING

T. +34 917374946 F. +34 918843865 int.service@rotorbike.com
www.rotorbike.com