ROTOR ALDHU ROAD Assembly Manual page 6

EN
Note: specifications are subject to change for improvement without notice. Revised: 03/2019
A
FRAME COMPATIBILITY
This user manual is only valid for BB90, BB86, BB30, PressFit
�
30, BBright, BB386, BSA and ITA road frames.
Bottom bracket not included with cranks package.
B
BB's, RINGS AND PEDALS INSTALLATION
Be sure to read and understand the user's manual provided by the bottom
bracket, rings and pedal´s manufacturer.
Read ROTOR bottom bracket, Q Rings® and pedals user's manuals:
1
OCP MOUNT INSTALLATION
Insert the axle (2) into the Direct Mount (1). To modify your Q Rings® OCP
adjustment, you must align the OCP reference line with the desired position
number in the axle.
2
RIGHT CRANK INSTALLATION
Position the drive side crank over the axle + chainring set.
Drive side crank arm must be placed over the area marked "POSITION
CRANK HERE" on the chainring.
Tighten the crank arm bolt with an 10 mm Allen key until the crank arm
touches the spider or Direct Mount.
3
NON-DRIVE-SIDE ASSEMBLY PREPARATION
Unscrew counterclockwise the preload bolt "T" with a 2 mm Allen key; do not
remove the bolt.
Tu rn the preload nut clockwise until it touches the crank arm area.
4
CRANKS INSTALLATION
Review the compatibility manual to select the necessary spacers for
installing ALDHU / VEGAST cranksets.
Install the correct drive-side spacers "DS" onto the axle. Insert the drive-side
assembly (drive-side-crank + axle + chainring) into the frame.
Install the selected non-drive-side spacers "NDS" onto the axle. Install the
non-drive-side assembly (non-drive-side crank arm + preload nut) onto the
axle.
5
TIGHTENING AND ADJUSTING
Tighten clockwise the drive-side crank bolt with an 10 mm Allen key to 35
Nm torque.
Tighten clockwise non-drive-side crank arm bolt with an 10 mm Allen key to
35 Nm torque.
Fine adjustment
#5.1 Turn the preload nut clockwise to eliminate any lateral play in the
crankset.
ALDHU / VEGAST ROAD.
INSTALLATION GUIDE
www.rotorbike.com