Philips AJ3112 User Manual page 5

Hide thumbs Also See for AJ3112:

Table of Contents

INSTALLATION

POWER SUPPLY

1 Check if the power supply, as shown on the type plate located on the bot-

tom of the set, corresponds to your local power supply. If it does not, consult

your dealer or service center.

2 Connect the

3 To disconnect the set from the power supply completely, remove the

plug from the wall outlet.

CLOCK MEMORY BACKUP

The clock memory backup allows your alarm and clock time settings to be stored

for up to a day when there is a power interruption e.g. power failure. The com-

plete clock radio and display illumination will be switched off. As soon as the

power supply returns, the display will indicate the correct time.

1 Remove the battery door to insert a 9 volts 6F22 type battery (not included)

for backup.

2 Replace the battery door.

NOTE: If no backup battery is installed or the power interruption is prolonged,

you will need to set the clock and alarm times again.

Batteries contain chemical substances so they should be disposed of

properly.

plug

to the wall outlet.

Table of Contents