Troubleshooting - Graco 980S Instructions-Parts List Manual

Non–bleed style turbine spray gun
Hide thumbs Also See for 980S:
Table of Contents

Advertisement

Spray Finish Problems
PROBLEM
Orange peel finish – Paint
surface not smooth
Blushing – Clear coatings
appear milky
Fish eyes – Small pools on
painted surface that will not
fill
Runs and sags
Solvent pops or bubbles

Troubleshooting

CAUSE
Paint droplets too large.
Paint droplets drying too fast to proper-
ly flow out of gun.
Cold weather spraying.
Moisture condensation is trapped in
the lacquer when spraying in hot, hu-
mid conditions.
Silicone contamination from lubricants,
grease, polish, or waxes on the sur-
face being sprayed.
Applying too much paint per pass for
the drying conditions.
Sprayed surface drying before solvent
gas can be released.
SOLUTION
Maintain proper spraying distance;
see page 12.
Keep the turbine air filters clean to
allow full air flow. See page 13.
Do not use an air hose that is too
long to provide sufficient atomiza-
tion pressure.
If droplets are still too large, reduce
the fluid or use a smaller air cap.
Keep the object being sprayed out of
direct sunlight. When spraying in
warmer temperatures, use a slower
evaporating solvent or a retarder.
Keep the fluid and the object being
sprayed as close to room temperature
as possible. When sprayed on a cold
surface, most paints will become too
thick to flow properly.
Allow the turbine to warm up a few
minutes before spraying.
Store the lacquer off concrete
floors, at room temperature.
Apply lighter coats and allow for
proper drying time.
Use a slower evaporating solvent
or retarder.
Do not spray in windy conditions.
Clean all parts with a cleaning solvent;
use a solvent rag and a clean rag to
wipe with. Replace rags as needed. If
the problem persists, use a fish eye
eliminator.
Move the gun faster or decrease
the fluid flow.
Maintain proper spraying distance;
see page 12.
Reduce the amount of thinner or
use a faster drying thinner.
Apply fluid in lighter coats to allow
for proper evaporation.
Use the recommended thinners.
Follow the solutions, above, for
Orange peel finish–paint droplets
too large .

Advertisement

Table of Contents
loading

Table of Contents