Yamaha XTZ07AR 2024 Owner's Manual page 26

Instrument and control functions
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch " /
Set this switch to "
beam and to " " for the low beam.
5
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
EAU98390
set this switch to "
"
the switch down towards " ". See
" for the high
page 7-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch "OFF/ "
With the main switch in the "ON" posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU66040
turn signal lights).
/ "
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
". When
might be a traffic hazard.
EAU66030
"
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU66061
/ / " gine not running, otherwise the bat-
tery may discharge.
", and then push
Wheel switch "
This switch operates the information
display and menu system.
" to stop the en-
Operate this switch as follows:
Rotate
ward/downward.
Short press - briefly press the wheel
inward.
EAUA0830
Long press - press the wheel inward
for one second.
TIP
 See page 5-5 for more information
 See page 5-11 for more informa-
5-3
"
- rotate the wheel
on the main display screen and its
functions.
tion on the menu system and how
to make setting changes.
ECA10062
EAU98024
up-