Table of Contents
Advertisement
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
SCRAPER BLADE
IMPORTANT: Damage to auger/impeller housing will
result if blade wears down too far.
Scraper blade is adjustable to compensate for wear.
To adjust scraper blade:
1. Tip unit back onto handlebar, support housing
and loosen nuts retaining blade.
2. Adjust runners to fully raised position (housing
closest to ground).
3. Reposition scraper blade flush with runners and
tighten lock nuts.
RUNNERS
Runners should be adjusted as conditions require
(Figure 14).
1. Position unit on a hard, flat, smooth level surface.
2. Adjust runners by inserting a spacer of desired
thickness under center of scraper blade, loosen
runner hardware, slide runners to flat surface.
Allow 1/8 in. (3 mm) between scraper blade and
hard smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or gravel
surfaces. Retighten hardware.
NOTE: Keep housing level by adjusting runners
equally.
2
1
1. Runner
2. Runner Hardware
Figure 14
SHEAR BOLTS
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger, breaking
shear bolts (Figure 15) which secure the auger to the
shaft. This allows auger to turn freely on the shaft
preventing damage to gear drive.
SERVICE AND ADJUSTMENTS
OS0482
GB - 19
2
Figure 15
For Replacement:
1. Align shear bolt holes in auger with shear bolt
holes in the shaft.
2. Drive shear bolt through hole (if shear bolt was
broken this will drive remaining part from shaft).
3. Secure shear bolt with nut.
DISCHARGE CHUTE DEFLECTOR
Deflector must stay in selected position while throwing
snow.
To adjust, loosen then retighten hardware to desired
deflector drag force (Figure 16).
Adjusting
Hardware
Discharge Chute
Deflector
Figure 16
1
2
1. Auger
2. Shear Bolts
OS1113
Advertisement
Table of Contents
