Installing The Light Kit And Glass Shade - Progress Lighting AirPro P250110 Installation Manual

CAUTION: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power off
using the fan switch is not sufficient to prevent
electric shock.
Step 1. Remove 1 of 3 screws from the posts of the
mounting plate and keep it for future use. Loosen
the other 2 screws. (Do not remove) (Fig. 15)
Step 2. While holding the LED light kit under your
fan, make the polarized plug connections: (Fig. 15)
- White to white
- Black to black
Step 3. Place the key holes in the LED light kit
over the two screws previously loosened from the
mounting plate. Turn the light kit until the light kit
locks in place at the narrow section of the key
holes. (Fig. 15)
Step 4. Securely tighten the two mounting screws
previously loosened and the one previously removed.
(Fig. 15)
Step 5. Raise glass shade up against the LED light
kit and secure it to fan by turning glass clockwise
until snug. DO NOT OVERTIGHTEN. (Fig. 16)

9. Installing the Light Kit and Glass Shade

Wire
connectors
Figure 15
Mounting
Plate
Glass
shade
LED light kit
Screws
Figure 16
LED light kit