Sony MEX-M72BT Service Manual page 8

MEX-M72BT/N5300BT/N7300BD
Ver. 1.1
4. The setting is completed by pressing the [PUSH ENTER MENU/
VOICE] button on the main unit or [ENTER] button on the re-
mote commander at the state of cursor position of "OP0", then
the display turns off, the initialization operation is done, and the
display returns to the clock display.
[PUSH ENTER
MENU/ VOICE]
press
Note 4: There is not displayed "AM", depending on the destination.
5. Perform the check whether there is no mistake in the destination
code.
In the state of source off (the clock is displayed on the liquid
crystal display), enter the test mode by pressing the buttons in
4] → [MIC 5] → [
order of the [
button for 2 seconds) and display the software main version.
(Displayed characters/values in the following fi gure are exam-
ple)
[ 4] [MIC 5]
press press
Software main version
Note 5: There is not displayed "AM", depending on the destination.
8
[ENTER] press
or
cursor position
of OP0
6] (press only the [
u
[u 6]
press for
2 seconds
6. In the state in which the software main version is displayed
on the liquid crystal display, enter the destination code display
mode by pressing the [DSPL
(Displayed characters/values in the following fi gure are exam-
ple)
Set to this state
of display.
6]
u
7. Confi rm the alphanumeric character of 6 digits on the liquid
crystal display is a value set in step 3.
Note 6: If the setting is incorrect, start from step 1 again.
Destination code (example: E, AUS)
8. Press the [ OFF SRC] button for 1 second or more to execute
reset and return to the normal condition.
[ OFF SRC]
press for
1 second or more
Note 7: There is not displayed "AM", depending on the destination.
9. This completes the destination setting work.
SETTING THE AREA/REGION
(MEX-N5300: AEP, UK/N7300BD)
After resetting the unit, the area/region
setting display appears.
1
Press ENTER while [SET AREA] is
displayed.
The area/region currently set appears.
2
Rotate the control dial to select
[EUROPE] or [RUSSIA], then press it.
3
Rotate the control dial to select [YES]
or [NO], then press it.
If the setting area/region is changed, the
unit is reset, then the clock is displayed.
This setting can be configured in the general
setup menu (page 19). .
Sony CONFIDENTIAL
For Authorized Servicer
SCRL] button 3 times.
[DSPL
press
Software main version
(Not used for the servicing)
Bluetooth address (BD_ADDR)
Destination code
(Not used for the servicing)
OP5 OP4 OP3 OP2 OP1 OP0
6 digits
SCRL]
SYS SET