Safety Instructions - Buffalo 600 Series Instruction Manual

Hide thumbs Also See for 600 Series:

Table of Contents

Safety Instructions

Electrical requirements:

Always switch off and disconnect the power supply

to the appliance before installation, when not in use,

before cleaning and maintenance/service.

This appliance should only be connected to the mains

electricity supply by a qualified electrician. Hardwire

the appliance into a suitable power supply with correct

voltage and sufficient power capacity. Refer to the

rating label on the appliance for voltage and wattage

requirements.

Connect the appliance to a circuit protected by an

appropriate RCD (Residual Current Device).

Under no circumstances put a plug on the cable.

Failure to comply with these safety instructions will

release Buffalo from any responsibility and the warranty

will become null and void.

• Position on a flat, stable surface.

• A service agent/qualified technician should carry out

installation and any repairs if required. Do not remove any

components on this product.

• Consult Local and National Standards to comply with the

following:

- Health and Safety at Work Legislation

- BS EN Codes of Practice

- Fire Precautions

- IEE Wiring Regulations

- Building Regulations

CU476-CU477_EN_A5_v1_20231020.indb 2

DANGER OF HIGH VOLTAGE!

2023/10/20 13:20

Table of Contents

Cu476 Cu477