Philips PM3055 Operation Manual page 27

3.2.7.1 Standard
Z—MOD
REMOTE CONTROL
LIN EIN
FUSE HOLDER
3.2.7.2 Optional
MTB gate
MTB sweep
DTB gate
Y-out
3.2.7.3 Remote control socket
3-13E
Input socket for Z-modulation of the c.r.t. trace. The trace is blanked when this input -
is "high" (+2,5 V or more)
Maximum limit voltages: O—12 V.
See Section 3.2.7.3.
Mains input socket, 90 V...264 V a.c., 45 Hz...440 Hz. For safety instructions, please
read Section 2.2. :
Fuse rating 1,6 A delayed action. For safety instructions, please read Section 2.2.
Output socket of a TTL-compatible signal, which is "high during the MTB sweep and
"low" for other conditions.
Maximum limit voltages: O—12 V.
Outpyt socket of the MTB sawtooth signal.
Maximum limit voltages: O~12 V.
Output socket of a TTL-compatible signal, which is "high during the DTB sweep and
"low" for other conditions.
Maximum limit voltags: 0-12 V.
Output socket of the vertical (Y) signal. This source can be selected with the MTB
trigger source A and B.
Maximum limit voltages: O—12 V.
Connector: D-subminiature connector with 9 female contacts.
543 2.1
O0O000
OOOO
9857 16
MAT 2369
Connector specification: ©
Connector Name
1 SDA
2 SCL
GND
FOOTN
onan oO
Additional information
Bidirectional data line for communication according to Philips 11C bus
protocol.
Bidirectional clock line for communication according to Philips 11C bus
protocol.
Ground for power supply and communication signals.
Remote AUTO.SET. Command line to initiate the AUTO SET function.
REMRON REMote ReQuest Not. Command line to initiate transfer to/from
+5 V
GND
+5 V
GND
oscilloscope.