Table of Contents
Advertisement
GIV1-H200
Speaker lead connection procedure
1. Loosen the four screws of the speaker terminals (Speaker Output)
on the rear of the amplifier.
2. Insert the end of each speaker lead between the speaker terminal
and its screw according to the mode to be used, and tighten the
screw.
Terminal screw
Speaker lead terminal
Connection of the battery power, and
ground leads
1. Pass the leads through the band for preventing short circuits.
• This band must be used.
3. Cover each terminal block with a short-circuit prevention band.
• This band must be used.
Short-circuit prevention band
2. Loosen the screws (x 2) of the terminals on the front panel of the
amplifier.
• Remove the screws (x 2) from the two battery power terminals.
Terminal screws
Remove only the screws of the
battery lead terminal. (Loosen
all the other screws.l
3. Connect the battery lead to the two battery lead terminals,
5. Slide the short-circuit prevention band over the terminals,
reinserting and tightening the screws (x 2).
4, Connect the ground lead to the two ground lead terminals,
tightening the screws.
Terminal screws
1 1
Advertisement
Table of Contents
