Controls And Indicators - Kenwood KT-3300D Instruction Manual

Controls and indicators
KENWOOD
POWER
SYNTHESIZER FM TUNER| KT- 33000
0N DOFF
Qprocram
QUIETING CONTRO
fee o o8-
PRESET FUNCTION] DISTANCE
Jrverlsiartsetuad en brip ue NORMAL,
——————— 7
@ POWER switch
Press this switch to supply power. Press the switch again
to turn the power off.
@ PROGRAM switch
This switch function for Program operations. Each time
the switch is pressed, the function is turned ON and OFF al-
ternately.
© Output level control (QUTPUT LEVEL)
This contro! adjusts the level of the OUTPUT level from the
output terminals on the rear panel. When set to MIN. the le-
vel is lowest and when set to MAX. the level is highest. It is
used to match the level of the FM output signal to the levels
of the signals from other source components (turntable, cas-
sette deck, etc.) when the tuner is used together with an am-
plifier.
@ PRESET STATION (A/B) switches
Two (A/B) FM stations can be stored in each PRESET STA-
TION switch. When the switch is pressed, the PRESET STA-
TION indici tor lights and the stored frequency is displayed
in the frequency display.
@ MEMORY switch
When this switch is pressed, the MEMORY indicator lights
and the unit stands by for preset station memory.
@ Preset function switches
Select the preset station. group between A (8 stations) and B
(8 stations) with this switch.
@ REC CAL switch
Use this switch to adjust the recording level of the tape deck
for FM broadcast recording. When this switch is set to ON,
the REC CAL indicator lights and a signal of about 400 Hz
(equivalent to 50% FM modulation, 100% = 75 kHz dev.) is
output at the OUTPUT jacks on the rear panel. With this sig-
nal, adjust the VU meter reading of the tape deck to -6 dB
or 50%. After setting the level, be sure to set the switch to
OFF.
6 _ KT-3300D (M)
Fig. 6
@ MODULATION switches
Press ON switch to display the modulation level. The
MODULATION indicator lights. Press OFF switch to disap-
pear the modulation level. The indicator goes off.
© IF BAND switches
Use these switches to select the pass band of the interme-
diate frequency between WIDE and NARROW.
WIDE: Set to this position for normal reception. High qua-
lity sound without distortion can be received.
NARROW: If the desired station is disturbed by a nearby
. station, set the switch to this position. Selectivity is im-
proved, resulting in interference-free reception.
@ RF SELECTOR switches
Along with the increase of stations, the RF intermodulation
or intermodulation noise becomes serious. To prevent this,
the RF SELECTOR switch is provided. It is recommended to
use these switches together with the IF BAND switch for
the best reception according to the receiving condition.
DIRECT: When this switch is pressed, the RF intermodula-
tion or intermodulation noise will be reduced and the best
quality sound is obtained. In a strong-signa! area, set to
this position for greater sound quality.
DISTANCE: When a distant station is required, set to this
position. The receiving ability is improved so that the
weak-signal station can be received with lower noise.
@ TUNING MODE switch
Each time this switch is pressed, the AUTO indicator lights
and goes off.
AUTO indicator ON: For automatic tuning
AUTO indicator OFF: For manuai tuning
@ TUNING LOCK switch
Use to lock the frequency being received. When this switch
is set to ON, the received frequency does not change even
when the TUNING knob is turned.
@ ANTENNA switch
This switch changes the antenna terminals A or B on the
rear panel.