Controls And Their Functions - Kenwood KT-7500 Instruction Manual

CONTROLS AND THEIR FUNCTIONS
oufPui
HIWB
i
■
r i EVfc«
ft <
If HAND MtHINO
-"• •—I
I I
s* ttc row
mmm
■MM
© ® © © ©
® POWER SWITCH
Move up to ON to power the set, down to turn it
OFF. The dial indicator lights when the power is
on.
© OUTPUT LEVEL CONTROL
The signals passing from the OUTPUT (VARIABLE)
terminals can be controlled by the OUTPUT
LEVEL knob. Use the controls in the following
situations:
1) When the KT-7500 is connected to a stereo
amplifier and the output level is too high for
the input terminals.
2) When the tuner output level does not match
that of other units (turntable, tape deck, etc.)
connected to the amplifier.
® TUNING KNOB
Use the tuning knob to select the AM and FM
station desired. Adjust further by tuning for maxi¬
mum deflection of the SIGNAL meter while listen¬
ing to the speaker output.
® IF BAND SELECTOR
Switch positions and functions are as follows:
WIDE — This setting is suitable for normal usage
in an area where no radio interference occurs.
Reception with a low distortion can be expected.
NARROW — This setting is to increase selectivity
against interference from a closely adjacent sta¬
tion.
© FM MUTING SWITCH
This switch silences the interstation noises on the
FM band. However, it may also silence the weak
signals of long distance FM stations or weaker FM
stations in which case it may be necessary to turn
off this switch.
© SELECTOR SWITCH
FM AUTO — For reception of both FM mono¬
phonic and stereo. The tuner will automatically
identify and separate FM stereophonic broadcasts.
When an FM stereo broadcast is tuned in, the
STEREO indication lights up.
MPX FILTER — Unlike FM monophonic recep¬
tion, high frequency noise may sometimes be en¬
countered when receiving FM stereophonic broad¬
casts. The MPX FILTER in this tuner effectively
cuts such disturbances. This switch has nothing
to do with monophonic reception.
FM MONO — For FM monophonic reception.
AM — For AM reception.
® TUNING METER
This meter is used for precise tuning to the center
of the FM channel. Turn the tuning knob until
meter pointer is at the center of the heavy black
area of the meter scale. Center tuning provides
maximum separation and minimum distortion.
® SIGNAL METER
This meter indicates incoming signal strength at
the antenna with correct linearity from the weakest
to the strongest signals.
KT-7500( K) 5