Operation - ProDevice GDX02 Instruction Manual

Instruction manual ProDevice DGX02

4. OPERATION

1. Place the shredder on a hard surface in the designated, sheltered installation area.
2. Secure the shredder against shifting by lowering its legs with a ratchet socket wrench.
3. Make sure the shredded scrap bin is in the compartment and that the compartment door
is closed.
4. Unlock the media input drawer lock to open it.
5. Insert the keys into the locks on the media input upper housing and open it.
6. Apply the oil for cutting knives.
7. Close and lock the media input upper housing.
8. Locate the lubrication points and apply grease to each of them.
9. Extend the power cord and plug it into a power outlet.
10. Turn on the shredder using the main switch.
11. Place the storage medium in the media input drawer and close it.
12. Start the shredder by pressing the START button.
13. Wait until the media is completely shredded.
14. Stop the shredder by pressing the STOP button or by opening the input media drawer.
15. Place another media in the media input drawer and press the START button to restart
the device.
16. In the event of overloading the device, the work of the shredding knives will be stopped
and the STOP button will be illuminated. To restart the shredder, close the media input
drawer and press the STOP button, then the START button.
17. In case of pressing the EMERGENCY STOP button, the work of shredding knives will be
stopped and the STOP button will be illuminated. To restart the shredder, close the media
input drawer and press the STOP button, then the START button.
18. To properly shut down the device, after the shredding cycle is complete, press the STOP
button and use the main switch.
19. Disconnect the power cord from the power outlet and store it in the housing unit.
www.pro-device.com
8