Possible Faults And Ways To Fix Them - ProDevice GDX02 Instruction Manual

Instruction manual ProDevice DGX02
9.

POSSIBLE FAULTS AND WAYS TO FIX THEM

Below are the fault descriptions and the required user responses:
Fault
The device does not turn on
The device does not turn on - socket ok
The device does not turn on - socket,
main switch ok
The device does not turn on - socket,
main switch, power cord ok
The device turns on but runs in opposite
speed
The device does not start working
The device does not start operation -
EMERGENCY STOP button ok
The drawer is blocked, it cannot be
pulled out
Switching off the device operation while
destroying the medium
Damaged cutting knife
Possible cause
No power at the wall socket
The plug is not properly inserted in the
wall socket
Main switch is off
The fuse in the installation has blown
Damaged power cord
-
Incorrect connection of the phase
conductors in the device plug or in the
power socket.
EMERGENCY STOP button pressed
START button disabled
Defective control panel
Drawer door, drawer top lid or waste bin
door not closed
Bad microswitch on drawer door, drawer
top lid and / or waste bin
The protection of the drawer blocks the
possibility of its opening
Motor overload
Operation of the device
www.pro-device.com
Way to remove the fault
Check that there is power in the outlet
by plugging in another electrical device
or by using a meter
Insert the plug into the wall socket
correctly
Insert the plug into the wall socket
correctly
Lift the fuse or, if it is damaged, replace
it with a new one with the parameters
recommended by the manufacturer
Replace the power cord with a new one
having the same specifications. THIS
OPERATION CAN ONLY BE
PERFORMED BY AN ELECTRICIAN
WITH VALID LICENSE!
Contact service
Disassemble the plug and swap the two
phase wires with each other. THIS
OPERATION CAN ONLY BE
PERFORMED BY AN ELECTRICIAN
WITH VALID LICENSE!
Pull up the EMERGENCY STOP button
Turn on the device by pressing the
START button
Contact service
Close the door and try again
Contact service
Pull the tab towards you to open the
drawer
Press the STOP button and then START
Contact service
18